-
●非對稱異性隧道聯絡通道冷凍法(07月24日)
-
●水泥夯土材料抗壓強度試驗及耐(08月25日)
-
●變質巖類順層邊坡破裂跡象及邊(07月25日)
-
●大體積混凝土配合比優化設計在(08月25日)
-
●粉煤灰基超高性能混凝土配合比(07月25日)
-
●地鐵車輛段檢修庫裝配式混凝土(07月24日)
-
●大型十字交叉地鐵車站結構地震(07月25日)
-
●變坡面淺埋偏壓小凈距隧道圍巖(07月24日)
-
●邯鄲富水地層深基坑支護優化和(07月25日)
-
●自密實抑溫防水復合材料在地下(08月25日)
-
●粉煤灰摻量對高層建筑筏板基礎(06月26日)
-
●基于遺傳算法的神經網絡對大體(06月27日)
-
●氯鹽漬土無側限抗壓強度及體變(06月25日)
-
●不同 ZrO2 摻量改性水(06月26日)
-
●非均勻銹蝕對建筑鋼混組合梁承(06月27日)
-
●再生微粉泡沫混凝土力學性能研(06月25日)
-
●堿激發粉煤灰-高爐礦渣粉固化(09月11日)
-
●地鐵車輛段檢修庫裝配式混凝土(07月24日)
-
●昌寧隧道豎井輔助正洞施工技術(07月03日)
-
●堅硬頂板沿空留巷充填體加固技(06月25日)
PDF全文閱讀
陳劍鋒 ,徐保林 ,鐘 佩 ,班明才 ,朱雙云
(中南勘察基礎工程有限公司 ,武漢 430081)
摘 要:為探討砂巖夾雜膨脹泥巖互層結構變形規律及對路基的影響,對平層 、斜層 、豎層三種重塑砂巖與泥巖膨脹巖互層產狀結構在不同層厚比、不同上覆荷載進行了室內模型試驗和有限元模擬分析。結果表明:產狀 、層厚比和上覆荷載對于互層結構膨脹巖變形的影響均較大,層厚比和上覆荷載越大,變形量越小,平層產狀影響最大,豎層產狀影響最小,斜層產狀影響居中;當互層結構膨脹力大于上覆荷載時,巖樣處于膨脹變形, 當互層結構膨脹力小于上覆荷載時 ,巖樣處于壓縮變形;平層產狀在 1 ∶1、2 ∶1 層厚比時,膨脹力介于 12. 5 ~ 25 kPa 之間,其余情況均小于 12. 5 kPa; 在最不利工況下 ,平層、斜層 、豎層三種互層結構對路基膨脹變形的影響長度 分別為 60 、30 、20 m。
關鍵詞:砂巖 ;膨脹泥巖 ;層厚比 ;產狀 ;上覆荷載 ;膨脹力 ;膨脹變形
中圖分類號:U213 . 1
文獻標志碼:A
文章編號: 1005- 8249 (2025) 01- 0055- 05
DOI:10. 19860/j.cnki.issn1005 - 8249.2025 .01 .011
CHEN Jianfeng , XU Baolin , ZHONG Pei , BAN Mingcai , ZHU Shuangyun
(Zhongnan Survey Foundation Engineering Co. ,Ltd. ,Wuhan 430081 , China)
Abstract:In order to explore the deformation law of sandstone interbedded with expansive mudstone and its influence on roadbed, indoor model tests and finite element simulation analysis were conducted on the interbedded structure of reshaped sandstone and expansive mudstone in three different layers: flat layer, inclined layer, and vertical layer, under different layer thickness ratios and overlying loads. The results show that the attitude, layer thickness ratio, and overlying load have a significant impact on the deformation of interlayer structured expansive rocks. The larger the layer thickness ratio and overlying load, the smaller the deformation. The influence of the flat layer attitude is the greatest, the vertical layer attitude is the smallest, and the inclined layer attitude is in the middle; When the expansion force of the interlayer structure is greater than the overlying load, the rock sample is in expansion deformation. When the expansion force of the interlayer structure is less than the overlying load, the rock sample is in compression deformation; When the layer thickness ratio is 1:1 or 2:1, the expansion force ranges from 12.5 to 25 kPa, while in other cases it is less than 12.5 kPa; Under the most unfavorable working conditions, the lengths of the influence of the three layered structures of flat, inclined, and vertical layers on the expansion deformation of the roadbed are 60 m, 30 m, and 20 m, respectively.
Key words:sandstone; Expansive mudstone; Layer thickness ratio; Attitude; Overburden load; Expansion force; Expansion
作者簡介: 陳劍鋒 (1978—) , 男,本科,高級工程師,研究方向:巖土工程檢測 、監測 、工程物探等。
收稿日期:2024 - 03 - 28
冀公網安備13011002000529 技術支持:數字河北 